46
Laser Seam Tracking System for Welding Automation. RF627Weld Series
RF627Weld [Revision 1.1.1] 03.08.2020
15.5.5.1.13. Template 13 "Gap width"
Template 13 consists of two lines that represent the profiles of two surfaces, and
calculates the coordinates of a middle point between them and the gap width.
Constraints
Measurements
Parameters
Line length
·
Line 0; the minimum length is 20
mm, the maximum length is
undefined.
·
Line 1; the minimum length is 20
mm, the maximum length is
undefined.
Endpoint distance with check
·
Distance between lines 0 and 1;
the minimum distance is 2 mm,
the maximum distance is
undefined.
Rotation angle
·
Angle of rotation from line 0 to
line 1; the minimum value is
undefined, the maximum value is
10°; the direction of rotation is
undefined.
Point between 2 points
·
Midpoint (between the end point
of line 0 and the starting point of
line 1).
Endpoint shift in direction
·
Width (distance between the end
point of line 0 and the starting
point of line 1).
-
