Parameter
Name
Type
Range
Default
<bool>
Bool
{0|1|ON|OFF}
0
Remarks
•
For the two channels (CH1 and CH2) that support this mode, changes made on
one channel (voltage/current setting value, OVP/OCP level and on/off status) are
applied to the other channel.
•
By default, the tracking function is disabled. It is usually used to provide
symmetric voltage for the operational amplifier or other circuits.
•
The tracking function only tracks the voltage/current setting value. The actual
output voltage/current will not be affected.
Return Format
The query returns 1 or 0.
Examples
:OUTP:TRAC ON /*Enables the tracking function for CH2.*/
:OUTP:TRAC? /*Queries the on/off state of the tracking function.
The query returns 1.*/
4.9
:SOURce Commands
:SOURce commands are used to set the voltage, current, OVP, and OCP of the
specified channel. While the :APPLy command offers the most straightforward
method to program the power supply via remote interfaces, :SOURce commands give
you more flexibility to change individual parameters.
4.9.1
[:SOURce[<n>]]:CURRent[:LEVel][:IMMediate]
[:AMPLitude]
Syntax
[:SOURce
[<
n>]
]:CURRent[:LEVel][:IMMediate][:AMPLitude]
{<
current>|
<
lim>|<amp>}
[:SOURce
[<
n>]
]:CURRent[:LEVel][:IMMediate][:AMPLitude]?
[<
lim>]
Description
Sets or queries the current of the specified channel.
Command System
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
57
Summary of Contents for DP2000 Series
Page 1: ......
Page 137: ...d Exit Programming Examples Copyright RIGOL TECHNOLOGIES CO LTD All rights reserved 129...
Page 145: ......
