Parameter
Name
Type
Range
Default
<n>
Integer
{1|2|3}
-
Remarks
•
[:SOURce[<n>]]:CURRent:PROTection:TRIPped?
to query whether
an OCP event occurred on the specified channel.
•
Before executing the command, make sure to remove the condition that caused
the overcurrent protection on the specified channel (you can either decrease the
output current to below the OCP level or increase the OCP level to be greater
than the output current). Execute this command to clear an OCP event that
occurred on the specified channel and enable the output of the corresponding
channel.
•
If [:SOURce[<n>]] or [<n>] is omitted, the command clears an OCP event
occurred on the current channel.
•
command to clear an OCP event that occurred
on the specified channel.
Return Format
None.
Examples
:CURR:PROT:TRIP? /*Queries whether an OCP event occurred on the
current channel. The query returns 1.*/
:CURR:PROT:CLE /*Clears an OCP event that occurred on the current
channel.*/
:CURR:PROT:TRIP? /*Queries whether an OCP event occurred on the
current channel. The query returns 0.*/
4.9.4
[:SOURce[<n>]]:CURRent:PROTection[:LEVel]
Syntax
[:SOURce
[<
n>]
]:CURRent:PROTection[:LEVel]
{<
current>|<lim>}
[:SOURce
[<
n>]
]:CURRent:PROTection[:LEVel]?
[<
lim>]
Description
Sets or queries the overcurrent protection (OCP) level for the specified channel.
Parameter
Name
Type
Range
Default
<n>
Integer
{1|2|3}
-
Command System
60
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
Summary of Contents for DP2000 Series
Page 1: ......
Page 137: ...d Exit Programming Examples Copyright RIGOL TECHNOLOGIES CO LTD All rights reserved 129...
Page 145: ......
