4 How to Use
4-5. How to wire
SD-1DGH
- 18 -
CAUTION
A bar terminal of the specified model must be used. Using other bar terminals invalidates the
warranty of the performance.
CAUTION
The right tools must be used.
In principle, one wire can be connected to one wiring hole.
When the wire is inserted into the driver slot by mistake, it does not contact the conductive part. This
may cause defective electric conduction or heating.
When the wire is inserted under the spring by mistake, it does not contact the conductive part. This
may cause defective electric conduction or heating.
Compatible bar terminal
For a bar terminal, the following items are available.
•
Bar terminal (ferrule): Model 216 Series (manufactured by WAGO)
•
Crimping tool: Model VarioCrimp 4 (206-204) (manufactured by WAGO)
<How to Connect to Terminal Plate>
When cables are connected to the connectors, use the dedicated lever or a flathead screwdriver to do it as
shown below.
NOTE
<How to Use the Dedicated Handling Lever>
To check whether the wire is connected securely, pull the wire gently. (Do not pull the wire strongly.)
Push the lever with your
finger to lower the spring in
its inside.
While holding down the lever, insert the wire
into the (round) wiring hole until it reaches the
deepest point.
Once the lever is released, the wire is secured.
