10
ASSEMBLY
Installing the Infeed Table
- Continued from page 9
3. Insert the bar through the table’s end hole and under-
side of the table. Then re-attach the Spring Washer and
Collar onto the Bar to secure it in place. FIG. 7.
4. Hold the infeed table up to the machine while threading
the depth of cut control bar into the Spacer Shaft (#137).
FIG. 8.
5. Install the infeed table by positioning it under the table
cover rails and wind the depth of cut bar until the upper-
most line on the depth Scale is registered. See FIG. 15,
page 12. Re-fit and secure the table cover rails, FIG. 9.
NOTE:
These rails should not be fully tightened, as the
table needs to slide up and down in order to adjust the
depth of cut. As a guide, fully tighten the socket head cap
screws and then back them off a 1/4 turn.
6. See page 12 for instructions on adjusting the table.
FIG. 7
FIG. 8
FIG. 9
INFEED
TABLE
underside
view
WASHER
& COLLAR
BAR
SPACER SHAFT
DEPTH OF CUT
CONTROL BAR
DUST OUTLET INSTALLATION
1. At the opposite, outfeed end of the machine, locate the
Chip Ejector Hood (#194). FIG. 10. Attach the Dust Port
(#195) to the outlet with the two hex Bolts provided. FIG. 11
FIG. 11
FIG. 10
CHIP EJECTOR HOOD
DUST PORT
CAP SCREW
COVER RAIL
DEPTH SCALE
Summary of Contents for 25-010
Page 31: ...31 WARRANTY...
