Rikon Power Tools 25-010, Operator'S Manual

5

THIS  SYMBOL  DESIGNATES 

THAT THIS TOOL IS LISTED BY 

THE INTERTEK TESTING 

SERVICES, TO UNITED STATES 

AND CANADIAN STANDARDS. 

SAFETY INSTRUCTIONS

                                  THE USE OF AN EXTENSION CORD 

WITH THIS MACHINE IS NOT RECOMMENDED. For 

best power and safety, plug the machine directly into a 

dedicated, grounded electrical outlet that is within the 

supplied cord length of the machine.

If and extension cord needs to be used, it should only 

be for a limited operation of the machine. The exten-

sion cord should be as short as possible in length, and 

have a minimum gauge size of 14AWG.

                                 Check extension cords before each 

use. If damaged replace immediately. Never use a tool 

with a damaged cord, since touching the damaged 

area could cause electrical shock, resulting in serious 

injury.

Use a proper extension cord. Only use cords listed by 

Underwriters Laboratories (UL). Other extension cords can 

cause a drop in line voltage, resulting in a loss of power 

and overheating of tool. When operating a power tool out-

doors, use an outdoor extension cord marked “W-A” or “W”. 

These cords are rated for outdoor use and reduce the risk 

of electric shock.

DO NOT MODIFY ANY PLUG.  

If it will not fi t the electrical 

receptacle, have the proper electrical receptacle installed 

by a qualifi ed electrician.

IMPROPER ELECTRICAL CONNECTION

 of the 

equipment grounding conductor can result in risk of 

electric shock. The conductor with the green insulation 

(with or without yellow stripes) is the equipment ground-

ing conductor. 

DO NOT

 connect the equipment grounding 

conductor to a live terminal if repair or replacement 

of the electric cord or plug is necessary.

CHECK

 with a qualifi ed electrician or service personnel  if 

you do not completely understand the grounding 

instructions, or if you are not sure the tool is properly 

grounded when installing or replacing a plug.

USE ONLY A 3-WIRE EXTENSION CORD THAT HAS 

THE PROPER TYPE OF A 3-PRONG GROUNDING PLUG 

THAT MATCHES THE MACHINE’S 3-PRONG PLUG AND 

ALSO THE 3-POLE RECEPTACLE THAT ACCEPTS THE 

TOOL’S PLUG.  *

REPLACE A DAMAGED OR WORN CORD 

IMMEDIATELY.

This tool is intended for use on a circuit that has a 120 

volt electrical receptacle. 

FIGURE A

 shows the type of the 

220v, 3-wire electrical plug and electrical receptacle that 

has a grounding conductor that is required if the motor

wiring is changed. See page 21.

IN THE EVENT OF A MALFUNCTION OR BREAKDOWN, 

grounding provides the path of least resistance for electric 

current and reduces the risk of electric shock. This tool 

is equipped with an electric cord that has an equipment 

grounding conductor and requires a grounding plug (not 

included). The plug 

MUST 

be plugged into a matching elec-

trical receptacle that is properly installed and grounded in 

accordance with 

ALL 

local codes and ordinances.

ELECTRICAL SAFETY

THIS TOOL MUST BE GROUNDED 

WHILE IN USE TO PROTECT THE OPERATOR FROM 

ELECTRIC SHOCK.

FIG. A

Sample of 220 volt plug required for this machine.

EXTENSION CORDS

    Keep the extension cord clear of 

the working area. Position the cord so that it will not 

get caught on lumber, tools or other obstructions while 

you are working with your power tool.

* Canadian electrical codes require extension cords to 

be certifi ed SJT type or better.

** The use of an adapter in Canada is not acceptable.

Consult a qualifi ed electrician 

if the distance of the 

machine from the electrical 

panel is greater than 30 feet.