www.rikontools.com
RIKON Power Tools, Inc.
Billerica, MA 01821
Mortising Attachment Kit
877-884-5167
Model # 29-201
SET UP
1. Place your workpiece on the drill press table and adjust the table
height so that the mortising chisel & bit are about 1/2” above the work.
2. Determine the depth of the mortise that you want to cut, and set
the drill press depth stop to this distance.
3. Set the fence distance so that the chisel & bit are in the location
that you want for drilling the mortise.
- Mark your workpiece with the exact location of the mortise(s) that
need to be drilled.
- Secure your work in place against the fence with the guide rods,
and also with the hold down bracket.
- Move the fence in or out until the chisel aligns perfectly with the
mortise lines that are marked on your work.
- Secure the fence in position with the two hex bolts that run
through the casting, fence and drill press table.
OPERATON
- Best drill press speeds are between 650 to 1800 RPM.
- Use lower speeds on hardwoods.
- Make sure the chisel is square/parallel to the fence.
- Test drill on scrap stock of the same woods of your
project to set the mortising positions, and drill press speed.
- First cut the outside, ends of the mortise, then make overlapping
cuts between the two to finish the mortise.
- Raise the chisel often to clear chips and prevent clogging.
CALFORNIA PROPOSITION 65 WARNING:
This product contains
chemicals known to the State of California to cause cancer and birth
defects or other reproductive harm.
NOTE: The specifications, photographs, drawings and information in this
manual represent the current model when the manual was prepared.
Changes and improvements may be made at any time, with no obligation
on the part of Rikon Power Tools, Inc. to modify previously delivered units.
DESCRIPTION
KEY NO.
MFG. PART NO.
1
2
3
4
5
6
7
8
9
10
11
12
13
Chisel Holder
5/16-18 x 2-1/2” Bolt
5/16-18 Hex Nut
Wing Nut with Treaded Stud
Hold Down Bracket
5/16-18 Wing Nut
Washer
Curved Guide Rods
Rod Holding Casting
Hold Down Steel Rod
Fence
5/16-18 x 4” Bolt
Hex Screw
P29-201-1
P29-201-2
P29-201-3
P29-201-4
P29-201-5
P29-201-6
P29-201-7
P29-201-8
P29-201-9
P29-201-10
P29-201-11
P29-201-12
P29-201-13
PARTS LIST
NOTE: Please reference
the Manufacturer’s Part
Number when calling in
for replacement parts.
KNOW YOUR POWER TOOL.
Read your
Drill Press’ manual to learn the tool’s operation, applications,
capabilities and its specific potential safety hazards.
