Rikon Power Tools 50-150, Owner'S Manual

8

Removal:

1. Remove and set aside mitre gauge.

2. Completely remove the disc-table adjustment 

handles.

3. Tip table up and remove.

4. Sanding discs are adhered to the plate using a 

“pressure-sensitive adhesive”. Remove sanding disc 

from disc plate. 

Installation:

5. Ensure disc-plate is clean.

6. Peel backing from new sanding disc.

7. Press new sanding disc firmly onto disc-plate.

Note: Hook & Loop sanding discs cannot be used with 

this type of sander!

8. Replace the sanding table and handles that were 

removed in step 2 (above).

Installing or Changing Accessories – Sanding 

Belts

WARNING! Turn the power off and remove the plug 

from the outlet before changing the accessories.

Removal:

1. Remove lock-knob and two Phillips screws;

2. Remove side cover.

3. Loosen tracking knob to release belt tension.

4. Remove belt from three wheels.

Installation:

5. Install new belt.

6. Replace side cover.

7. Before using, check belt tracking as described in 

“Belt Tracking” section, and adjust as necessary.

Fig. 08

Fig. 09

Fig. 10