user is advised to read, defines an EN12941 TH2P R SL device as offering an Assigned
Protection Factor of 20.
The CR-2B01/2013 can only provide this level of protection when used with filters provided by
the manufacturer marked “ CR-2B01/2013 ” and “EN12941:1998 TH2P R SL”.
The CR-2B01/2013 is certified with the GT-2B01/2013 helmets which is certified to EN 175 B.
The CR-2B01/2013 is manufactured under ISO 9001:2000 Quality System.
Welding helmet
GT-2B01/2013
3. Preconditions for use:
This Respirator must be used strictly in accordance with this instruction leaflet and the
instructions supplied with the corresponding head-units (hoods).
The user must read and understand all the following "Instructions for Use" well to be able to use
the respiratory protective system correctly.
When the blower unit is switched off little or no respiratory protection is to be expected. When
the blower unit is switched off a rapid build up of carbon dioxide and depletion of oxygen within
the head unit may occur and so it is essential not to use the blower unit when it is switched
off.
THE UNIT MUST NOT BE USED:
•
In an atmosphere that is immediately hazardous to user hygiene or health and
or has oxygen content of less than 17% or contains unknown substances.
•
In confined spaces or unventilated areas such as tanks, pipes, canals etc.
•
Near to flames and or sparks
•
In areas with danger of explosion.
•
In an area where there are high winds.
•
If the blower unit stops working due to any reason, the user must leave the contaminated
area immediately.
•
If no filter is installed.
It is also essential that:
•
Nothing is allowed to touch the moving parts.
•
There is no attempt to modify or alter the unit or filter in any way
•
Water or other liquids enter the unit in any way – in particular the motor and fan, the filter
or the battery.