Rimage Producer IIIN+ 6100N, User Manual

20

2001475_A

Rimage Producer™ IIIN+ User Guide  

7100N/8100N/6100N/6100

9. 

Manually, slightly rotate the 

carousel

 so that the distance between 

the edges of the carousel and the edge of the disc is equal on all 
four points, as shown. 

Note: 

The edge of the disc should not touch any part of the 

carousel. If you cannot center the carousel in this step, the lift 
arm may need to be readjusted. 

10. 

Press the 

operator button

. 

•  The lift arm lowers and pins the disc into the bottom of bin 1 to measure the gear-train backlash of the carousel.  

Note: 

The operator panel displays [BACKLASH O+00000 N+00000], where O+00000 is the old offset value and 

N+00000 is the new offset value based on the current position of the carousel adjusted for backlash.

•  The lift arm releases the disc into bin 1.

•  The autoloader exits diagnostic test 3 and the system restarts.

Note: 

Diagnostic test 3 causes the autoloader to exit diagnostic mode. To continue the diagnostic tests, refer to 

the 

Access and Select Diagnostic Tests

 section on page 16.

Align the Printer

This section provides instructions to align the Everest or Prism printer to your autoloader.

#

Required tools:

•  Torx T25 screwdriver

•  5/32"Allen wrench

1. 

Power on the 

autoloader

. Refer to the 

Power On the Producer III 

section on page 12.

2. 

Wait for the autoloader to complete initialization.

Tip: 

The autoloader takes one to two minutes to complete initialization.

3. 

Open the 

front door

 of the autoloader.

4. 

Prepare the system for alignment.

a. 

Manually, slowly move the 

lift arm 

to 

the top of the column.

b. 

Place a 

disc 

on the lift arm. Press the 

disc into the gripper while you press 
the disc release button.

c. 

Press the 

printer button

. The printer 

tray opens.

Lift Arm

Disc Release Button

Gripper

En

gli

sh