8 | Checks and servicing during operation
112 / 148
User and maintenance manual
8.2.3.4
Maintenance of steering system
Deformed or defective steering components must be replaced without delay.
Fig. 65:
Maintenance of steering system
1 Screws of steering bearing holder
2 Screws of steering wheel
3 Steering bearing holder, top
4 Screws of steering wheel mount
5 Steering bearing
6 Screws of tie rods
7 Steering column bearing, bottom
Replacement of steering system components
The kart is switched off.
a)
Position the kart safely at an ergonomically suitable height, for instance by placing it on an assembly trolley
or a lifting platform (e.g. KHB 250 EH, prod. no.1397002).
b)
Remove the screws at the steering wheel.
c)
If necessary, disconnect all electronic connections from the steering wheel.
d)
Loosen the screw of the
steering wheel mount and remove the steering wheel mount.
e)
Unscrew the screw of the
steering bearing holder, top and remove the upper shell of the steering bearing holder.
f)
Open the lock ring at the top of the steering bearing and loosen the clamping ring.
g)
Loosen the bearing by taping the edge of the bearing slightly with a rubber mallet from the bottom. Remove
the bearing.
h)
Remove the screws of the
tie rods.
i)
Remove the screws of the
steering knuckles.
j)
Remove the nut and the brass washer of the
steering column bearing, bottom from the steering column.
k)
Replace all parts that need to be changed with original RiMO spare parts.
2
1
7
6
3
2
4
5
1
