Checks and servicing during operation | 8
User and maintenance manual
113 / 148
l)
Assemble and mount the dismantled components following the above instructions in reverse order. Observe
the prescribed tightening torques for the screws:
Screws of steering wheel = 10 Nm
Screw of steering wheel mount = 30 Nm
Screws of steering bearing holder, top = 25 Nm
Screws of tie rods = 30 Nm
Steering column, bottom = 20 Nm
Screws of steering knuckles = 45 Nm
For all other tightening torques, refer to chapter
8.2.3.5
Maintenance of steering alignment system
See also
Maintenance/change of wheels [
8.2.3.5.1
Checking tracking alignment
The tracking alignment must be checked with a tracking alignment tool.
See also
8.2.3.5.2
Checking steering knuckles
–
Inspect the steering knuckles for damage and excess play on a weekly basis. The steering knuckles must
not be bent or cracked. The steering knuckles must not be stiff, and the bearings must not show any play in
any direction when the steering knuckles are under load.
