If the tractor does not have any 3-pin plug attachments,
adapt its system with the same 3-pin plugs that come with
the machine considering the scheme here on the side.
Connect the two 4mm
2
diameter cable groups with max.
impedance 18A directly to the 12V battery of the tractor,
one group for every 3-pin attachment to add to the existing
system.
For every group insert on the red power cable a 20A
fuse for the 3-pin plug of the oil cooler and a 10A fuse to
the 3-pin plug on the control panel
.
Connect the 3-pin plugs to the tractor using the piercing
mask printed on the blister, then connect the cables to the
3-pin plugs paying attention to respecting polarity.
3 pin power plug
3-pin plug
of the oil cooler
The machines that we deliver personally or pack and ship partially assembled are provided with grease in the
hydraulic system, bevel gears, and gearbox, unless directed otherwise; they are tested thoroughly after assembly by
having them turn at full speed and the hydraulic ram end stops have been adjusted.
If indicated by the corresponding label, in order to prevent hydraulic oil from leaking from the hydraulic system’s
tank, substitute the
closing top
from the hydraulic tank’s hose with
a top with vent/air filter
with the machine in a
perfectly horizontal position.
If the machine is delivered without hydraulic oil in the hydraulic unit’s tank (this will be indicated in the
accompanying documentation), it is necessary to fill it before starting to use the machine.
Use a mineral oil grade
ISO VG 46
for hydraulic units like, for example, Mobil DTE 25 and
a discharge/aspiration
oil filter
with metal net of µ60 with a flow of 54 L/min.
Make sure that all levels are equal to those described in the MAINTENANCE chapter.
Apply the GS-GE to the tool using the coupling frames (Fig.8 Tab.1/A and 13 Tab.1/B).
Apply the machine to the tractor using appropriate pins (Fig.50 and 52 or 4 and 7, Tab.6) and, if necessary, use
adaptor bushings.
The tractor should be heavy enough to counterbalance the machine when it is fully hoisted so that the front tires do
not lose their grip.
Lift the machine up as high as possible and tighten the arms until there are not more than 5 cm. margin left; It is
absolutely necessary that the third point is at the center of the tractor.
Set the top link of the tractor’s three-point-hitch when the machine is resting on its wheels or skids by lengthening or
shortening the top link until the machine results completely horizontal.
Crimp
or sold
Fuse
10A control
panel
Fuse
20A oil
cooler
