Rinnai New Zealand Ltd (0800 746 624)
INFINITY pipe cover
Installation guide
INF pipe cover installation 9509-F
I
06-20
2 of 2
Pipe cover installation
1. Fit the pipe cover to the water heater using
the two short stainless steel PK screws and
nylon washers.
2. Use the #10 x 40 ZP PK screws to fasten
the rear bracket to the wall. Use suitable
anchors for the wall if required (not
supplied).
Fitting the front panel
1. Fit the two slots in the lower edge of the
front panel onto the tabs of the bottom
bracket. Where necessary readjust the
pipe cover assembly to align with the water
heater and that all components are still
square.
2. Use the two M4 INFINITY pipe cover
screws (M4 plastic capped thumbscrews) to
fasten the front panel to the top frame.
3. Turn on the power, water, and gas to the
water heater.
Locating tab
