22
SOFTEN&COOL lamp (green)
Air is blown into the drum while
it is operated intermittently
(drum is rotated for 30 seconds
approximately every four
minutes) together with cool
operation after drying ends. This
makes it less likely for wrinkles
to occur, and keeps clothes
fl
uffy during drying. During
cool operation, this lamp lights
(green).
*
To immediately stop cool
operation, perform the
following:
1. Press the “Start / Pause”
switch to stop operation.
2. Open the front door, and be
sure to remove the clothes.
3. With the front door open,
hold down the “Power”
switch until you hear a
beep.
(See pages 34.)
This lights to notify you when too much
lint has accumulated on the lint fi lter inside
the equipment. When this lamp is lit (red)
or is blinking, perform maintenance on the
lint fi lter.
(See page 49.)
Filter cleaning lamp (red)
Lamp indications
(lit green) In operation
(lit red) Gas burning in
progress
(blinking green) Paused
(See pages 32, 37 and 40.)
Operation/combustion
lamp (green/red)
This lights to notify end of
drying.
FINISH lamp (green)
Start/pause operation.
“Start / Pause” switch
This turns the power ON
and OFF.
If the power is left ON, it
is automatically turned
OFF after approximately
ten minutes. (auto off)
“Power” Switch
This is used to switch the operation course.
• Each press switches the course.
(See page 32.)
Course selection switch/lamp (green)
Summary of Contents for RDT-42-CH-W
Page 63: ...62 中国RoHS法规标示要求 ...
Page 64: ...RDT62 0280 00 220326 ...