Rinnai 26
RDV 600_700ER IM
CERAMIC STONE SET INSTALLATION
Carefully unpack and inspect each stone for damage one at a time, temporarily returning each of the stones to
the packaging for safe keeping until required. If
ANY
damage is evident on the stones
DO NOT
continue with
installation and contact your supplier for advice.
Complete steps 1 through 3 of the "Ceramic Log Set Installation" on page 24
Step 4 . Remove Log Positioning Pins
When installing stones it is necessary to remove the Log locating pins as follows.
The front pins
(A)
are held into the stone guard by a single screw, undoing this screw will allow each pin to be
removed.
The rear pins are mounted to support brackets
(B)
, each support bracket is attached to the burner box floor with
two screws. The entire pin/bracket assembly for the pins is to be removed. However, the four fixing screws for the
support brackets
MUST
be screwed back into the floor of the burner box.
IMPORTANT
Once removed place all the pin components in a safe place as they will be required if a log set is
to be installed in the future.
Step 5. Stone Placement
A set of instructions is attached to the burner box glass has pictures of the suggested stone media placement, use
these pictures as a basic guide to the stone placement, the key element to good stone placement is the avoidance
of repetitive patterns, be this due to shape and or colour.
Step 6 . Charcoal Bed Installation
Use the same method described on 25 Step 5. Charcoal Bed Installation to place the black burner granules and
the brown burner fibre around the stones onto the burner.
IMPORTANT
DO NOT
force any granular or fibrous materials into the burner ports or completely block any of
the burner ports.
Keep the flame probe media
(C)
free of any direct contact with any of the burner media.
Step 7 . Replacing the Burner Box Glass
Replace burner box glass panel assembly in the reverse sequence to that explained on 24 in Step 1. Removing
the Burner Box Glass.
BURNER MEDIA INSTALLATION
