MAINTENANCE AND CARE
En
gl
ish
Disconnect the power supply cord before carrying out
any cleaning or maintenance activities. It is important
to clean and/or replace the filters at appropriate
intervals as grease deposits build-up increases the risk
of fire. Do not operate the extractor hood without
grease filter.
Aluminum Charcoal Sponge Filter
(Fig. 10)
•
Filters are used to absorb the grease particles formed
during cooking process.
•
To remove the Aluminum charcoal filter, unscrew
the two thumbscrews (Point B of Figure 10.1) and
remove the S/S panel.
Oil collector removing reference drawing steps
(Fig.11)
.
•
The charcoal filter should be replaced when it is
dirty or discolored, or when the control panel
shows time to replace.
Fig.
10
.2
Cleaning the appliance body
Clean the extractor hood using warm detergent
solution and a soft damp cloth. Wipe dry with a lint-
free cloth.
•
Avoid using corrosive or abrasive products that could
damage the surface.
Light replacement
Kindly contact Rinnai customer care service for
replacement of LED light bar.
You are strongly recommended to follow these
safety instructions. The manufacturer will not be
held liable for any damages to the appliance or
any fire hazard due to failure to observe the above
safety recommendations.
7
Fig.11
•
•
•
B
Fig.
10
.1
Fig.
10
•
Pull down the latch to remove the aluminum
Charcoal Sponge Filter. (Fig 10.2)
•
These charcoal filters are not washable and cannot
be restored.
To remove the oil collector, push the collector
bar towards the front.
•
•
To fix in the oil collector, slot in the oil collector
bar by inserting it to the 2 sided guide and
push backward to lock the oil collector
Removal of Oil Collector
