– 14 –
INSTALLATION INSTRUCTIONS
Check to ensure gas type on rating plate matches gas being supplied to the unit. If not, unit may have
been converted and should be checked to ensure conversion was done properly. If not, unit could be
damaged due to being overfired.
Refer to local gas authority for confirmation of gas type if in doubt.
Refer to data plate located inside of the front panel.
Check for damage. If the unit is damaged, contact your supplier or Rinnai.
Do not install a damaged unit before checking with your supplier.
Refer to an approved pipe sizing chart if in doubt about size of gas line.
Flue Manifold
.......................
1
Spare rubber seal
...................
1
(‘A’ Flue units only)
(For weatherboard installations)
Back Spacer
Set
1
1
1
2
1
1
3
10
2
1
1
1
Insulation
Clip
Plastic tie
for air inlet
Clamp
Wall Bracket
Spacer
Bracket
Pipe Stopper
Manual Valve
Set
Screw
Screw
Screw
Owner’s Manual
Conversion Manual
(For Back Spacer)
(For Flue Manifold)
(For Clamp)
5
Screw
(For Wall Bracket
and Flue manifold)
Summary of Contents for RHFE-263FA 2
