Be sure that power cord must not contact to exhaust
Be sure that power cord must not contact to exhaust
part on the back side.
part on the back side.
Exhaust part is extremely dangerous to contact
power cord by high temperature can occur fire
accident.
Must get rid of air in the gas pipe when first use or not used long time.
Must get rid of air in the gas pipe when first use or not used long time.
I
t may happen bad ignition or noizy and lifting flame before air
clearance.
Repeat ignition few times for clear bad ignition or lifting flame.
Make sure that electrical wire installation before use.
Make sure that electrical wire installation before use.
Check proper voltage and Herz of the product
and your place.
We strongly recommend to install by authorized
person with licence or Rinnai agent.
Must ground the product.
It should be installed circuit breaker at
t should be installed circuit breaker at
distributing board.
distributing board.
(Capacity of circuit breaker shoud be over 30mA)
(Capacity of circuit breaker shoud be over 30mA)
Assemble exhaust air duct to exhaust hole attached back side of
product and fix it with 2pcs of bolt(M4) included.
When installing over 2 items, maintain the
distance between the 2 products over 30cm.
Space for service performance.
Space for service performance.
Over 30cm
Height adjustment
Circuit
break
Keep flat condition at bottom
part.
A
djust the height by leg of the product.
djust the height by leg of the product.
Summary of Contents for RRA-106
