![background image](http://html1.mh-extra.com/html/rinstrum/x300-ip69k376/x300-ip69k376_reference-manual_1463190055.webp)
Reference Manual V1.16
Software Versions 4.xx
Page 52
003X-652-116
13.
Special Functions Key
13.1. Introduction
The K376 firmware allows for the <FUNCTION> key to be configured to a range of
special functions. As the K376 firmware allows for check weighing, there is an
additional special function available where the key can be used to gain access to the
check weighing threshold values.
Refer to KEY.FN (
page 35 to configure the function key.
When leaving the factory, the <FUNCTION> key is blank and has no function pre-
programmed. Each function has an associated overlay sticker supplied that should
be applied to the function key to label the function. Ensure the keypad is clean and
dry before affixing the sticker. Refer to Cleaning page 7 for more information.
13.2. Key Functions
NONE
When set to
NONE
the special function key is not used during normal operation. This is the
default setting.
TEST
Press the
<TEST>
key to clear the display then show all segments of the display then clear
the display again before returning to normal operation.
COUNT
Use this key to perform pieces counting. Press the
<COUNT>
key to switch between weight
display and counts display. The instrument annunciator shows
p
for pieces.
To record a new sample, do the following:
Tare off any containers.
Place the sample on the scale
Press and hold the
<COUNT>
key for two seconds. The default number of items in the
sample will be displayed.
Use the
<SEL>
and
<EDT>
keys to alter the number of items.
Press
<OK>
and the current sample will be stored against the entered items.
If printing is enabled the sample quantity and weight will be printed.
UNITS
Use the
<UNITS>
key to switch the displayed reading between
lb
and
kg
. This will affect the
displayed and printed weight but will not affect any data entry. The following is a sample of a
printout displaying kg and lb.
000009 06/05/2003 16:31
2.8 kg G
000010 06/05/2003 16:31
6.1 lb G
NOTE: in
K35x
, if extended unit switching is turn on it will switch the reading between
kg, lb, o
and
g.
HOLD and PEAK HOLD
The
<HOLD>
key implements a manual
Hold
function. The
<PEAK>
key implements a
Peak
Hold
function where the largest absolute weight, either positive or negative is stored in the
Summary of Contents for X300 IP69K376
Page 1: ...X300 IP69K K376 K378 Digital Indicator Reference Manual...
Page 3: ...Notes...
Page 75: ...Notes...
Page 76: ......