30
Serial Interface
Command list
Message header:
X/
Command Function
Remarks
C
Reset KS-93
Single
R
Set local mode/remote mode
R0
Activate local mode
R1
Activate remote mode
S
Set measurement data send mode
S0
Activate S0 mode (data sent after measurement)
S1
Activate S1 mode (data sent after D command)
L
Turn light source on/off
L0
Turn light source off
L1
Turn light source on
G
Measurement start/stop
Single
G0
Stop measurement
G1
Start measurement
G2
Cancel measurement
- All characters are ASCII codes.
- "Single" means that the command must be sent by itself. If sent together
with other commands, the other commands will not be executed.
Summary of Contents for KS-93
