CR1280 FULL TOWER
Troubleshooting Your New CR1280
The Front panel LED for Power and HDD activity does not lit.
The polarity of the LED cables matter, and they are not connected as they should
(inverted polarity), connect the positive cable marked as “+” to the right mother-
board “+” pin header, do the same for the negative, (refer to your MB manual to
identify the right pin headers.)
RGB component is not working (i.e. fan spins but no light)
The RGB controller can only use RGB Prism fans (sold separately), If a non
RIOTORO RGB PRISM class fan is connected , it will force the whole RGB control-
ler out of sync, therefore only use appropriate RGB fans if you wish to add more
Lightning to the RIOTORO PRISM controller.
How to clean the Dust filters.
The CR1280 comes with dust filters, and are meant to help keep the computer
components clean, blocking the dust from the outside, they are located across
several points that could potentially be used as intake areas. (Fresh air intake)
- Magnetic filters: simply detach those filters, and use compressed canned air.
- Slide in filters: usually located on the bottom of the case, this needs to be
gently pulled out, and use canned air to clean, once done just push it
back to its position.
- Front bezel Foam filter: to access this, just pull the bezel from the bottom.
Once detached, Use canned air to clean it and then reinstall it
24 Chapter 2 Ready, Setup, Go
Summary of Contents for CR1280
