background image

Specifically: use of the swim spa in a non-residential 
application; damage caused by the operation of the 
swim spa outside the specified voltage requirements 
(230+ –10%) or operation of the swim spa at water 
temperatures  outside  the  ranges  of  1°C  and  42°C; 
damage  caused  by  voltage  spikes  or  “brown-out” 
conditions;  damage  caused  by  dirty,  clogged  or 
calcified  filter  cartridges;  damage  caused  by  the 
use of trichloro chlorine, chemical tablets in a floater, 
acid or by any other spa / pool chemicals or cleaners 
which  are  not  recommended  by  Riptide;  damage 
caused by allowing undissolved sanitising chemicals 
to  lie  on  the  swim  spa  surface  (no  swim  spa  can 
withstand this kind of abuse); damage to components 
or surface caused by improper pH balance or other 
improper water chemistry maintenance; and damage 
to the swim spa surface caused by leaving the swim 
spa  uncovered  while  empty  of  water  and  in  direct 
exposure to sunlight (causing solar heating distress) 
are considered abuses and will invalidate warranty. 

The  standard  swim  spa  covers  are  not  designed  to 
support heavy weight loads and should not be used 
as a seat. In extreme cases the lid could crack and 
break.  This  occurrence  is  considered  abuse  and  is 
not covered under this warranty. 

Hercules™  covers  (optional)  are  designed  to  take 
the weight of an average adult walking across it only. 

Excess weight may still cause damage to the cover 

and will not be covered under warranty.

disclaimers 

Riptide shall not be liable for loss of use of the Riptide 
swim spa or other incidental, consequential, special, 
indirect  or  punitive  costs,  expenses  or  damages, 
which may include but are not limited to the removal 
of  a  permanent  deck  or  other  custom  fixture  or  the 
necessity for crane removal. Any implied warranty shall 
have a duration equal to the duration of the applicable 
warranty stated above. Under no circumstances shall 
Riptide  or  any  of  its  representatives  be  held  liable 
for  injury  to  any  person  or  damage  to  any  property 
however arising. 

Riptide Pools Limited
United Kingdom 

21

extent of warranty 

This  warranty  extends  only  to  the  original  consumer 
purchaser of the Riptide swim spa when purchased 
and originally installed or relocated in the boundaries 
of  the  country  of  purchase.  The  Riptide  swim  spa 
warranty  terminates  upon  any  transfer  of  ownership 
or if the swim spa is installed or relocated outside the 
country of purchase. The customer must register their 
purchase with Riptide. at the below address to benefit 
from this warranty. 
 

warranty performance 

In the event of a malfunction or defect covered under 
the terms of this warranty, an authorised service agent 
of Riptide will repair the Riptide swim spa. To obtain 
service,  contact  the  authorised  service  agent  who 
sold you the swim spa. There is no charge for parts 
or labour to repair the swim spa or its components. 
Service agents reserve the right to assess reasonable 
call  out  fees  or  travel  based  upon  their  individual 
policies.  If  the  swim  spa  is  installed  outside  of  the 
normal servicing area of the selling dealer, or if normal 
access to the swim spa is not possible, extra travelling 
expenses and costs of access will be charged. These 
costs are not covered by this warranty. 

Riptide maintains an extensive service network. In the 
event the consumer purchaser should not be able to 
either  obtain  service  or  satisfactory  service  from  an 
authorised service agent, notify the service department 
of Riptide. Written notice of any malfunction or defect 
must  be  given  within  ten  (10)  days  of  the  time  the 
malfunction is discovered, and must be accompanied 
by  the  original  consumer  purchaser  receipt  of  the 
swim spa, which shows the date of purchase. Notice 
must  be  given  Riptide  Pools  Limited,  41  Robjohns 
Road, Chelmsford, Essex, CM1 3AG, UK 
Tel 01245 265036 

acts invalidating warranty 

This  warranty  is  void  if  this  Riptide  swim  spa  has 
been  improperly  installed,  subjected  to  alteration, 
misuse  or  abuse,  or  if  any  repairs  on  the  swim  spa 
are  attempted  by  anyone  other  than  an  authorised 
representative  of  Riptide.  Alteration  shall  include 
component or plumbing change, electrical conversion 
or  the  addition  of  any  non-approved  sanitation  or 
water  purification  device  or  heating  system  which 
contributes to a component or unit failure or unsafe 
operating system. Misuse and abuse shall include: any 
operation of the swim spa other than in accordance 
with Riptide’s printed instructions, or use of the swim 
spa  in  an  application  for  which  it  is  not  designed. 

Summary of Contents for Manta SuperPro























Reviews: