background image

When  installing  and  using  this  electrical  equipment,  basic 

safety precautions should always be followed, including the 

following: 
1. read and follow all InstruCtIons. 

2. warnInG - to reduce the risk of injury, do not 

permit children to use this product unless they 

are closely supervised at all times. 
3

. In standard form the Riptide Nautilus or Manta SuperPro 

requires only one supply of 240 volts 32 amp. Please consult 

with a qualified electrician to verify current legislation 

always use a QualIfIed eleCtrICIan 

to ConneCt tHIs swim spa to your 

eleCtrICIty supply 
4. danGer - risk of accidental drowning.

 Extreme 

caution must be exercised to prevent unauthorised access 

by children. To avoid accidents, ensure that children cannot 

use the Riptide swim spa unless they are supervised at all 

times. 

5. danGer - risk of injury. 

The suction fittings in the 

Riptide swim spa are sized to match the specific water flow 

created by the pump. Should the need arise to replace the 

suction fittings or the pump, be sure that the flow rates are 

compatible. Never operate the Riptide swim spa if the suction 

fittings are broken or missing. Never replace a suction fitting 

with one rated less than the flow rate marked on the original 

suction fitting. 

6. danGer - risk of electric shock.

 Do not permit 

any electric appliance, such as a light, telephone, radio, or 

television, within 5 feet (1.5m) of the unit. These units have 

an integral ground fault circuit interrupter, but this only covers 

the pools own electrics.

7. warnInG - to reduce the risk of injury: 

a) Before entering the swim spa check the temperature. 
b) Since excessive water temperatures have a high potential 

for  causing  foetal  damage  during  the  early  months  of 

pregnancy,  pregnant  or  possibly  pregnant  women  should 

seek  advice  before  using  pool  and  should  maintain  safe 

water temperatures. 
c) The counter-current of the Riptide swim spa is extremely 

powerful and could cause injury if used incorrectly. Do not 

stand next to the counter-current nozzles when the motor is 

running. Ideally you should be placed at least 1 meter from 

the  nozzles.  Never  attempt  to  adjust  the  swim  jet  nozzles 

whilst the motor is running 
d) The use of alcohol, drugs, or medication before or during 

swim  spa  use  may  lead  to  unconsciousness  with  the 

possibility of drowning. 
e) Persons suffering from obesity or with a medical history of 

heart disease, low or high blood pressure, circulatory system 

problems,  or  diabetes  should  consult  a  physician  before 

using swim spa. 
f)  Persons  using  medication  should  consult  a  physician 

before  using  the  swim  spa  since  some  medication  may 

induce drowsiness while other medication may affect heart 

rate, blood pressure and circulation. 

addItIonal safety InstruCtIons: 
1. warnInG - risk of fatal hypothermia. 

a)  The  use  of  alcohol,  drugs,  or  medication  can  greatly 

increase the risk of fatal Hypothermia in a swim spa. 

b) The causes, symptoms, and effects of Hypothermia may be 

described as follows: Hypothermia occurs when the internal 

temperature  of  the  body  reaches  a  level  several  degrees 

above the normal body temperature of 37°C (98.6°F). The 

symptoms of Hypothermia include an increase in the internal 

temperature of the body, dizziness, lethargy, drowsiness, and 

fainting. The effects of Hypothermia include: 
• Unawareness of impending hazard; 

• Failure to perceive heat; 

• Failure to recognize the need to exit the Pool; 

• Physical inability to exit the Pool; 

• Foetal damage in pregnant women; and 

• Unconsciousness and danger of drowning. 

2.  warnInG  -  risk  to  infants,  the  elderly,  and 

women planning pregnancy or during pregnancy. 

Please consult your physician if the above applies to you or 

anyone using your swim spa. 

3. warnInG - risk of children drowning. 

Although 

your Riptide swim spa cover is not rated as a safety cover, it 

is wise to always keep the swim spa cover securely fastened 

when  not  in  use.  This  will  help  discourage  children  from 

attempting to enter the swim spa when not supervised by 

an adult. 

4. warnInG - risk of drowning. 

Use caution when 

bathing alone. Overexposure to hot water may

cause nausea, dizziness, and fainting. 

5.  warnInG  -  risk  of  injury.

  Always  use  extreme 

caution while entering or exiting the swim spa. Surfaces can 

be very slippery when wet. Do not step on or sit on head 

rests. Keep all breakable objects out of the swim spa area. 

6. warnInG - risk of injury. 

Never use the swim spa 

immediately after strenuous exercise. 

7. warnInG - risk of injury.

 Individuals with infectious 

diseases should not use the swim spa 

8. warnInG - risk of injury. 

Maintain water chemistry 

in accordance with chemical manufacturer’s instructions. 

9. warnInG - risk of shock. 

The swim spa shall not be 

operated in severe weather conditions, i.e. electrical storms. 

10.  CautIon  -  unauthorised  access. 

Secure  the 

swim spa area against unauthorised access. Make sure all 

barriers meet local codes. Keep the swim spa cover on swim 

spa when not being used. 

11.  CautIon  -  risk  of  damage  to  pool  or 

equipment. 

By  performing  maintenance  as  described 

later in this Owner’s Manual, the chance of damage to your 

swim spa and it’s equipment will be greatly reduced. Never 

block the air vents that lead to the equipment compartment. 

Doing so may cause the swim spa equipment to overheat. 

12. CautIon - non-approved accessories. 

Using 

accessories  not  approved  by  the  manufacturer  could  void 

your guarantee or cause other problems. Please consult with 

your authorised Riptide dealer. 

13. CautIon - location of your riptide swim spa. 

Locate  your  Riptide  swim  spa  on  a  surface  that  can 

withstand  the  weight  bearing  requirements  of  the  swim 

spa (see Selecting a Site for your Riptide swim spa in this 

Manual). Also, locate your swim spa in an environment that 

can withstand repeated exposure to water and the possibility 

of a major spill.

IMPOrTanT saFeTY InFOrMaTIOn 

3

Summary of Contents for Manta SuperPro























Reviews: