Risco Agility, User Manual

Agility User Manual                                                                                                  

Page 13 

Duress disarming: 

If you are ever coerced into disarming your system, you can comply with the 

intruder's wishes while sending a silent duress alarm to the Central Station. To do 

so, you must use a special duress code, which when used, will disarm the system 

in the regular manner, while simultaneously transmitting the duress alarm. To use 

a duress code, add 1 to the last digit of your user code, as shown in the table 
below: 

User Code 

Duress Code 

1-2-3-4

1-2-3-5 

5-6-7-8

5-6-7-9  

6-7-8-9 

6-7-8-0 

Note:

 Under no circumstances must the duress code be used haphazardly or without reason. 

Central Stations, along with Police Departments, treat duress codes very seriously and take 
immediate action.  

Silencing an Alarm: 

When silencing an alarm the system goes into a disarm state. The 

Agility

 will 

indicate information regarding the cause of the alarm.

To disarm using

Procedure

Press

. All the partitions assigned to the 2-way remote control 

code will be disarmed.   

Note:

 If the Quick Disarming option is disabled for the bi-directional remote 

control you must enter the remote control PIN code after pressing the 

 key. 

Press 

 followed by your user code 

or

 hold your proximity 

tag for 2 seconds from a distance of 1-2 cm from the center of the 

keypad's door until audible confirmation sound is heard. The system 

will announce the disarmed partitions 

Press 

 and then enter your user code. 

Press the 

Ð

 button. All partitions assigned to the button will be 

disarmed.  

Note

: If an alarm occurred in the system, it is recommended to leave the premises. Only after police 

investigation should you consider that the burglar is no longer on your premises and you can re-enter. 

In special cases (if programmed by your installer) arming the system after an alarm might require a 
technician code. For more information refer to your installer.