Risco Agility, User Manual

Agility User Manual                                                                                                  

Page 15 

Chapter 3 Remote System Operation 

3.1 Remote Phone Operation 

The 

Agility 

enables you to operate the system from a remote touch-tone phone by 

initiating a telephone call to or from the system and interacting with voice menus that 

guide you through your required remote operation.  

Remotely Accessing the System 

Remotely accessing the system involves initiating a call to the system, and entering your 
remote access code and the user code you usually enter in the system keypad. 

To remotely access the system: 

1.

From a remote touch-tone telephone, dial the number of the premises where 

Agility

 is installed.  

2.

If your system is connected to a land telephone line and an answering 
machine is in use at the premises

 let the line ring once, then hang up and call 

again. 

If an answering machine is not in use at the premises

 wait until the system 

picks up. After the system picks up a short tone is heard. 

Note:

 When the system picks up, all phones on the same line are effectively disconnected and 

cannot be used. 

3.

Enter your 2 digit remote access code within 10 seconds.  The following message 

is announced: 

"

Hello, Please Enter Your User Code, Followed By

[#]

". 

The default 2 digit remote access code is 00. 

4.

Enter your user code followed by [#]. 

5.

After your code is accepted a system status message is announced, followed by 

the 

Operations

 menu. You can now perform the required remote operations. 

Voice Operations Menu 

The 

Voice Operations

 menu announces options and instructions on how to use the system 

functions. The options in the Operations menu vary according to system status and your 

access rights.  
Following is a list of the remote operations options: 

Operation 

Quick Key Combination 

Arming all partitions 

Press 

[1][1]

Arming a selected partition 

Press 

[1][9]

 followed by the partition number 

Disarming all partitions 

Press 

[2][2]

Disarming a selected partition 

Press 

[2][9]

 followed by the partition number