Page
23
User Manual
GARDTEC
872
Area Setting (using Master or Global Main codes)
1)
With the display showing
T M
Enter a Master or global Main code.
2)
The display will show
R D
(flashing) Press YES to start setting the system,
the exit tone will sound.
3)
To turn Area 1 Off press YES, 1
and / or
To turn Area 2 Off press YES, 2
and / or
To turn Area 3 Off press YES, 3
and / or
To turn Area 4 Off press YES, 4
and / or
To turn Area 5 Off press YES, 5
and / or
To turn Area 6 Off press YES, 6
and / or
To turn Area 7 Off press YES, 7
and / or
To turn the Cleaner Area Off press YES, 0
4)
Exit the premises or retire to an unprotected part of the system. At the end
of the exit time the exit tone will stop provided the system was clear.
Note:
Areas must first be programmed by the installation company.
Area Setting (using Area codes)
Area codes are only effective to their own area with the exception of the cleaner area
which may be turned off by an area code (only if all areas are in the unset condition).
Removing Zones
(Master & Main codes only)
If programmed by the installation company individual zones may be removed, this may
only be done by a Master or Main level of code.
It should be noted that if an Area
Main code is being used only zones associated with that area may be removed.
1)
With the display showing
T M
Enter a Master or Main level code.
2)
The display will show
R D
(flashing), press NO.
3)
The Display will show
L D
(flashing), press YES.
4)
The display will show
L -
5)
Enter the zone number you wish to remove followed by YES.
PR5407.qxd 05/11/2003 15:12 Page 23
