Page
3
GARDTEC
800 Series
User Manual
Introduction
The Gardtec 872 control panel is a multi zone microprocessor controlled unit. Two
types of display are available for the system keypads, a) LCD offering a 32 character
display with zone descriptors and user names or, b) Twin seven segment LED displays
offering limited control/user programming options. The LED type displays normally
used for setting and unsetting at secondary points.
Please take time to familiarise yourself with the type of equipment fitted to your
premises as it will prove invaluable whilst using this manual.
User Code Types
99 user codes are available offering 19 code types with varying levels of access to the
system. User number 1 will always be a Master Level User but the remaining User
Codes may be programmed (by a Master Code) to the required level of access. These
may be changed at any time via a Master level code
The User Code levels available and the functions available for the levels are:-
Master
Allows Setting, Unsetting, Zone Remove (if programmed by
engineer), Test System, View Log, Chime On/Off, User
Codes, Set Time/Date, Reset After Alarm (if programmed
by engineer), Unsetting.
Cleaner
Full System Setting (from unset system),
Cleaner Area Unsetting (from set system),
Cleaner Part Set (from part cleaner set system).
Area 1 to 7 User
Allows Area 1 to 7 Setting, Area 1 to 7 Part Setting,
Area 1 to 7 Unsetting.
Main User
Allows Setting, Part Setting, Zone Remove (if programmed
& Main User 1 to 7
by engineer), System Test, Unsetting, Reset after Alarm (if
programmed by engineer). Main User 1 to 7 are specific to
their area.
Control
Used for control of other equipment (see installation
company for details).
Set Only
Only Allows for the setting of the system.
Note:
For information on using Duress on the Gardtec
872
see Using
Duress Section.
PR5407.qxd 05/11/2003 15:12 Page 3
