12
LightSYS2 Quick User Guide
Telephone Control Commands
Remark: Available only if your LightSYS is equipped with a voice module.
Receiving a call:
1.
Pick up the phone.
2.
Say “Hello” press [#]. You will
hear an event announcement
message.
3.
Choose an option from the
Acknowledgment menu
.
Acknowledgment menu
Acknowledge message: [1]
Acknowledge and stop all dialing: [2] [User
code] [#]
Access Operations menu: [3] [User code] [#]
Listen and Talk: [6] [3] [User code]
Repeat the event message: [#]
Repeat the Acknowledgment menu: [*]
Calling the System
:
1.
Dial the number of the
premises.
If an answering machine is
present at the premises: Let
the line ring once, hang up
and call again.
If an answering machine is
not in use at the premises:
Wait until the system picks
up. You will hear a
continuous tone.
2.After the tones, enter the 2-digit
remote access code.
3.Enter your user code followed by
[#].
4.Choose your option from the
Operations menu
.
Operations Menu
:
Arming all Partitions: [1] [1]
Arming by Partition: [1] [9] [Partition no.]
Unsetting all Partitions: [2] [2]
Unsetting by Partition: [2] [9] [Partition no.]
Changing Zone Omit: [3] [Zone no.] [#] [9]
Operating Programmable Outputs: [4] [PO no.]
Changing FM Numbers: [5] [FM no.] [#] [2]
[New phone no.]: [#] [1]
Listen in:[6] [1]
Talk: [6] [2]
Listen and Talk : [6] [3]
Record Messages : [7]
Exiting the System: [0]
Repeat the Menu: [#]
Return to previous menu: [*]
© RISCO Group 2020. All rights reserved.
02/2020
5IN2053 C
