01/2022
Page 43
5IN2933
Defining Zone Bypass Status
If installer-configured, you can perform either the following procedure to bypass zones, or
the quick procedure for one-time-only bypassing (see
Quickly Bypassing/Un-Bypassing Zones
➢
To define a zone's bypass status:
1.
At the keypad, enter your Grand Master or
user code, and then press
OK
.
2.
Scroll to
Activities
and then press
OK.
3.
At
Bypass
press
OK.
4.
At
Zones
press
OK.
5.
Scroll to select from the following bypass options:
•
One Time Only:
Bypasses the selected zone once only
–
at the next system arming
(the zones will then not be bypassed at subsequent armings)
•
Permanent Bypass:
Bypasses the selected zone on a continual basis, upon each
system arming
•
Bypass Reset:
Un-bypasses (removes the bypass) for all zones
•
Bypass Recall:
Reverts to the most recent zone-bypass state (if a Bypass Reset was
recently performed)
6.
Perform the following additional steps in the table below, according to the option you
select:
NOTES:
•
The default for all zones is
N
(not bypassed)
•
If a zone is bypassed, the full arming indicator does not display on the keypad
when in full arming (Away arming) mode
Summary of Contents for LightSYS Plus
Page 1: ...LightSYS Plus User Manual ...
