ProSYS Installation and Programming Manual
93
33
Utility Output
The Utility Output menu provides access to submenus and their related programming
parameters that enable you to choose the event that will trigger a selected Utility Output, as
well as the manner in which the output will be applied.
Adding one or more Utility Output expansion modules to the system makes an extensive list
of switched output possibilities available.
After you access the Utility Output menu from the main Installer Programming menu, as
described in this section, you can access the following submenus:
33
00
Nothing
, page 93
33
11
System
, page 94
33
22
Partition
, page 96
33
33
Zone
, page 99
33
44
Code
, page 100
To access the Utility Output menu:
1
From the main Installer Programming menu, press
[3]
, or press the
/
or
/
keys until you find the number
[3] Utility Output
option and then press
/
. The following display appears:
2
Enter a two-digit number for the Utility Output that you want to program, using a leading
zero for numbers between 1 and 9 (for example,
01
,
02
, and so on) and then press
/
. The following display appears:
You can now program the selected Utility Output. Use the information shown below. Each
of the system's Utility Outputs is assigned to a single type of event relating to one of the
following four major categories:
[1] System
[2] Partition
[3] Zone
[4] User Code
33
00
Utility Output: Nothing
The Nothing option enables you to disable the selected utility output.
To access the Nothing option:
Access the Utility Output menu and enter the appropriate two-digit number, as described on
page 93.
