WatchIN Installation Manual
16
DIP Switch Settings
DIP Switch
Number
Description
1 - 5
Used to set the detector ID number. Set the ID number in the same way as for
any other ProSYS accessory (Refer to the table below).
6 - 10
Not used
WatchIN ID: DIP Switches 1 - 5
ID 1 2 3
4
5
ID
1
2
3
4
5
01 OFF OFF OFF OFF OFF
17 OFF OFF OFF OFF ON
02
ON OFF OFF OFF OFF
18 ON OFF OFF OFF ON
03 OFF
ON OFF OFF OFF
19 OFF ON OFF OFF ON
04
ON
ON OFF OFF OFF
20 ON
ON OFF OFF ON
05 OFF
OFF
ON OFF OFF
21 OFF OFF ON OFF ON
06
ON OFF ON OFF OFF
22 ON OFF ON OFF ON
07 OFF
ON
ON OFF OFF
23 OFF ON
ON OFF ON
08
ON
ON
ON OFF OFF
24 ON
ON
ON OFF ON
09 OFF OFF OFF ON OFF
25 OFF OFF OFF ON
ON
10
ON OFF OFF ON OFF
26 ON OFF OFF ON
ON
11 OFF
ON OFF ON OFF
27 OFF ON OFF ON
ON
12
ON
ON OFF ON OFF
28 ON
ON OFF ON
ON
13 OFF
OFF
ON
ON OFF
29 OFF OFF ON
ON
ON
14
ON OFF ON
ON OFF
30 ON OFF ON
ON
ON
15 OFF
ON
ON
ON OFF
31 OFF ON
ON
ON
ON
16
ON
ON
ON
ON OFF
32 ON
ON
ON
ON
ON
ProSYS Programming (from ProSYS software
version 7.xx and above)
The following section describes the additional software programming options, added to the
ProSYS software, that concern the settings of the WatcIN DT as a BUS detector. Up to 32
BUS detectors can be added to the system (16 in ProSYS 16) and each of them comes at the
expense of a zone in the system.
It is recommended to read and fully understand the ProSYS Installation Manual (P/N: 5IN1383)
and User Manual (P/N: 5IN1382), before programming the WatchIN.
Notes:
The WatchIN is compatible with the ProSYS software Version 7.xx and above.
The WatchIN can be programmed via the U/D Software supporting ProSYS software Version 7.xx and
above.
For maximum operation stability, it is best NOT to exceed a total of 300 meters (1000 feet) of wiring when
connecting the WatchIN to the BUS.
Adding / Deleting the WatchIN DT
The WatchIN is part of an accessory category, BUS zones. Therefore, Adding/Deleting the
WatchIN is identical to any other accessory with the following exception:
Each BUS Zone Detector should be assigned to a Regular Zone
.
Any BUS detector can be assigned to a physical wired zone or to a virtual zone
.
Physical zone
: Any zone on the ProSYS PCB (zones 1-8) or on a wired zone expander
(ZE08, ZE16).
Virtual zone
: Any zone on a BUS zone expander defined as BZ08 or BZ16.
Summary of Contents for WarchIN RK325DT
Page 2: ......
