RISE VUSION FPV RACER, Instrustion Manual

9

battery voltage drops to 10.5V. You should land the quadcopter as soon as 
possible when you hear or see the alarm to avoid damaging the battery. The 

Vusion will autoland when the battery voltage gets below 9.7V. The flight battery 

should always be recharged before it is stored.

Warning:

 Your battery life will be reduced and the battery can be damaged 

any time the battery voltage is below 9V. Charging a LiPo battery that is damaged 
in any way can pose a fire hazard.

EXTERNAL RECEIVER

WARNING:

 Remove the props before connecting an external receiver to the Vusion.

The VUSION FPV RACER can be adapted to use an external receiver (one wire 

for each channel) with the RISE2509 Cable Set. 

Note:

 The stock transmitter must 

be used if recording photos or video by the on board DVR is desired. 

The transmitter should have a new model set up using the following chart as a guide.

CHANNEL ASSIGNMENTS

MODEL TYPE: Airplane

NOTE: Spektrum/JR systems should have opposite directions.

Channel

Aileron

Elevator

Throttle

Rudder

Gear

AUX

Direction

normal
reverse
reverse
reverse
normal
reverse

Dual Rates

80/100
80/100

80/100

Expo

-20/0
-20/0

-20/0

End Points

100/100
100/100
100/100
100/100
100/100
100/100

SWITCH ASSIGNMENTS - Ch 5

AUX
AUX
AUX

-100%

0%

100%

Stability 1
Stability 2

Rate

If your transmitter can set failsafe values for all the channels, set the roll & pitch channels 
to midstick and the throttle to its lowest setting to stop the motors. For transmitters that 
only set failsafe on the throttle channel, set the throttle to its lowest setting.

1 Black

 (Ground)

2 Red 

(+5V)

3 White
4 Purple
5 Yellow
6 Green
7 Yellow
8 Black

Ground
+5V
Aux (CH 6)
Gear (CH 5)
Rudder
Throttle
Elevator
Aileron

RECEIVER

EXTERNAL RECEIVER CONNECTIONS

ADAPTER PLUG

Plug the 8 wire cable into the receiver as shown. Channel 6 must be assigned to 
a switch so it can be used to change flight modes.