11
MOTOR ARMING & TAKEOFF
Turn on the transmitter and connect the flight battery to the RXS255. Place the
quadcopter on a level surface and let it sit for 10 seconds to let the flight controller
set up the gyros.
Arm the motors by holding the yaw control to the right for at least 3 seconds, and
center the left stick. The motors will start spinning when the motors are armed.
Advance the throttle to take off.
To disarm the motors after landing the RXS255, hold the throttle at its lowest
position and move the yaw control to the left. When the motors stop, release the
left stick.
SPARE PARTS
1 RISE2551 Front Carbon Arm w/2 Motor Power Distribution Boards
2 RISE2552 Rear Carbon Arms (2) w/2 Motor Power Distribution Boards
3 RISE2553 Landing Skids (4)
4 RISE2554 Hatch Latch Assembly
5 RISE2555 Carbon Frame Set
6 RISE2556 CC3D Flight Controller
7 RISE2557 Motor with Propeller Nut
8
RISE2558
Main
Board
9 RISE2559 Video Transmitter (200MW)
10 RISE2560 Cloverleaf
Antenna
11 RISE2561 ESC with BLheli & Oneshot
12 RISE2562 PPM Adapter & Cable Set (not in drawing)
13 RISE2563 Camera
14 RISE2564 Propeller Nut Set (4)
15 RISE2565 Spacer
Tubes
16 RISE2566 Screw
Set
17 RISE2567 Propeller Set 5x 4.5 BN (4)
18 RISE2568 Antenna
Mounts
19 RISE2569 Camera
Mount
20 RISE2570 Body
Set
