11
If you are using the House Racer/Vusion stock controller,
1.
Turn off the transmitter and unplug the battery from the House Racer for at
least 15 seconds.
2.
Connect the battery to the House Racer.
3.
Turn on the controller within 10 seconds.
The status LED should be steady and the House Racer should beep once to indicate
that it is linked to the controller.
An SLT transmitter like the Tactic TTX650 can also be linked to the House Racer.
Before linking the transmitter, make sure that servo reverse settings and the switch
assignments match the following table.
CHANNEL ASSIGNMENTS
Channel
Aileron
Elevator
Throttle
Rudder
Gear
AUX
Direction
normal
normal
normal
normal
normal
normal
Dual Rates
70/100
70/100
70/100
Expo
-30/-15
-30/-15
-30/-15
End Points
100/100
100/100
100/100
100/100
100/100
100/100
SWITCH ASSIGNMENTS - Ch 6
AUX
AUX
AUX
100%
0%
-100%
Stability 1
Stability 2
Rate
SWITCH ASSIGNMENTS - Ch 5
Gear
Gear
-100%
100%
Normal
Flip
1.
Turn off the transmitter and unplug the battery from the House Racer for at
least 15 seconds.
2.
Turn on your transmitter.
3.
Connect the battery to the House Racer.
After a few seconds, the status LED should be steady and the House Racer should
beep once to indicate that it is linked to the controller.
NOTE:
After the initial linking procedure is completed, always turn on the controller
before
connecting the battery to the House Racer.
Replacing a Motor
Removing a motor on the House Racer is very easy.
1.
Unplug the motor wire connector from flight controller with a small flat
blade screwdriver.
2.
Pull the motor wire from the arm.
3.
Remove the propeller and prop guard.
4.
Twist the motor cap to unlock it from the arm and remove it.
5.
Push the motor up and out of the motor housing.
Before installing the new motor, make sure the wire colors are the same as on the
old motor.
