8
Flight Modes
The Vusion has 3 flight modes.
Mode 1
– This mode has
autolevel, mild roll rates and
limited tilt angles. Ideal for the
pilot that is moving up from
an entry level quadcopter.
Mode 2
– This mode still has autolevel, but has higher roll rates and higher control
sensitivity. This mode is for the more experienced pilot.
Mode 3
– This mode (rate mode) has no limits on tilt and faster roll rates. The
quad will not autolevel in this mode. This mode offers the most maneuverability
and the ability to manually roll and flip, but requires the pilot to be able to control
the attitude of the quadcopter at all times.
It normally takes a week or two of practice to learn to fly rate mode. Start by
flying Line of Sight (no FPV) until you can comfortably control the quad. When
you are comfortable making a manual flip, you should be ready to fly FPV in
this mode.
Takeoff and Landing
Turn on the transmitter and connect the flight battery to the VUSION HOUSE
RACER. Place the quadcopter on a level surface and let it sit for 10 seconds to
let the flight controller set up the gyros.
To take off, arm the motors and advance the throttle at a moderate speed until the
House Racer is at least 3 feet above the ground.
To land, hover the Vusion over the landing spot and slowly reduce the throttle.
When the quadcopter is on the ground, disarm the motors.
IMPORTANT!
Always unplug the battery as soon as you land.
Recharge before next use.
Auto-Flip
The House Racer can auto-flip when in Flight Mode 2.
1. Press the button on the left side of the controller.
2. Move the right stick in the desired flip direction.
3.
Release the stick and button as soon as the flip starts so the controller is
ready for use when the flip is completed.
Switch
Position
Away
Middle
Forward
Tilt
Angle
30
45
360
Roll
Rate
Low
Medium
High
Stability
Mode
Stability
Stability
Rate
Mode 1
Mode 2
Mode 3
FLIGHT
MODES
