东方日升新能源股份有限公司
PV module installation and
maintenance manual
RISEN ENERGY CO.,LTD.
主导部门：组件研发中心
Page：NO.41 ,Total 41
Spot check to verify whether there is soot deposit on the module surface;
Check to whether there are visible scratches on the surface of the module or not;
Check whether there is no man-made cracks on the module surface or not;
Check whether the module support structure is leaning or bent or not;
Check whether the connectors of the module are detached or not
，
After cleaning, fill out the
PV module cleaning record.
13. Troubleshooting
If the PV system does not work properly, please inform your installer immediately. It
is recommended to perform a preventive inspect
ion every six months, please don’t
change any modules of the modules. If electrical or mechanical properties are
required for inspection or maintenance, qualified professionals should be advised
to avoid any electric shock or loss of life.
14. DISCLAIMER
Risen is not responsible for any form of damage, including but not limited to module
operation and system installation error, and personnel injury, hurt, and property
loss resulted from failure to follow the instructions in this Manual.
Failure of the customer to follow the requirements outlined in this Manual during the
installation of the module will result in the invalidity of product's limited warranty.
Risen is not responsible for any infringement of third party patents or any other
rights arising from the use of solar PV modules.
Risen reserves the rights to change this Manual without prior notice.
The information in this Manual is derived from knowledge and experience, and such
information and recommendations do not constitute any warranty.
This Manual is available in electronic form only. Please call our customer service hotline
(400-8291-000) if you need a hard copy. In case of any discrepancy between the Chinese and English
versions of this Manual, the Chinese version shall prevail. Risen reserves the rights to interpret this
Manual.
