If value outside this range is entered, it will display “INVALID VALUE”
followed by correct range of parameter.
If the value is set as 0000, the timer will keep repeating the cycles
until 9999 cycles are complete or the timer is stopped by the user.
Refer Section 9.3 for more details.
INVALID VALUE
RELAY-1 NO. OF CYCLES
Note:
1) To turn ON the relay in timer mode, visit “TIMER STATUS” submenu of SYSTEM
submenu in measurement screens.
2) The live status of No. of Cycles, ON & OFF delay is aslo available to the user in “TIMER 1”
and “TIMER 2” submenu of SYSTEM submenu in measurement screens for relay 1 and relay 2,
respectively.
3.2.4.1.3.2 Timer Configuration
The option decides the relay configuration for timer output. Two
options are available:
1.
ENERGIZED RELAY
: Energize on start
2.
DE-ENERGIZED RELAY
: De-energize on start.
Touch on “ key” will conrm the setting and take back to the
previous screen.
Touch on “ key” will take back to the previous screen.
3.2.4.1.3.3 On Delay
LINE-NEUTRAL VOLTAGE
VL2
VL2
VL2
LINE-NEUTRAL VOLTAGE
VL2
VL2
VL2
LINE-NEUTRAL VOLTAGE
VL2
VL2
VL2
CT SECONDARY
5 AMPERE
1 AMPERE
LINE-NEUTRAL VOLTAGE
VL2
VL2
VL2
LINE-NEUTRAL VOLTAGE
VL2
VL2
VL2
LINE-NEUTRAL VOLTAGE
VL2
VL2
VL2
RELAY-1 TIMER CONFIGURATION
ENERGIZED RELAY
DE-ENERGIZED RELAY
OK
BACK
OK
OK
BACK
The value decides the time in seconds taken by the relay in timer
configuration before tripping after it is started.
Here 0 to 9 digit input keypad is provided to set the On Delay & user
can confirm this value with a simple touch on “ key”. and cancel
the change by touching the “ key”.
The valid range is 1 to 9999 seconds.
If value outside this range is entered, it will display “INVALID VALUE”
followed by correct range of parameter.
ENTER
BACK
SET ON DELAY IN SEC
RELAY-1 TIMER ON DELAY
32
Summary of Contents for Master 3440iDL 0.2SS
Page 2: ......