3.2.5.2.1 Time Based Datalog Status Selection
Touching the “STATUS” option of Section 3.2.5.2 will provide a
confirmation dialog.
If logging is turned off, then touching “ ” will turn on the Time
Based Datalogging while touching “ ” will make no change.
If it is turned on, then touching “ ” will turn off the Time Based
Datalogging while touching “ ” will make no change.
TIME BASED DATALOGGING
TIME BASED DATALOG
ARE YOU SURE YOU WANT TO START
TIME BASED DATALOGGING
NO
OK
YES
NO
OK
YES
Caution: The settings for time based logging (see Section 3.2.5.2.2 & Section 3.2.5.2.3) are not
editable if time based datalog selection is turned ON (see Section 3.2.5.2.1).
3.2.5.2.2 Time Interval Selection
The value decides the time interval between two successive time
datalog entries.
Here 0 to 9 digit input keypad is provided to set the Time Interval &
user can confirm this value with a simple touch on “ key”. and
cancel the change by touching the “ key”.
The valid range is 1 to 60 minutes.
If value outside this range is entered, it will display “INVALID VALUE”
followed by correct range of parameter.
ENTER
BACK
ENTER INTERVAL IN MIN
DATALOG TIME INTERVAL
3.2.5.2.3 Parameter Selection
The parameter for time based datalogging can be selected out of the
available options by first touching the checkbox infront of it to enable
the selection and then touching the corresponding button to get the
available parameters.
Maximum 30 and minimum 1 parameter(s) can be chosen.
The list of available parameters is given in TABLE 3.
TIME DATALOG PARAMETERS
1. INPUT VOLTAGE VL1
2. INPUT VOLTAGE VL2
3. INPUT VOLTAGE VL1
4. INPUT VOLTAGE VL1
37
Summary of Contents for Master 3440iDL 0.2SS
Page 2: ......
