8 -
CZ80 / CV860 Rev. .0
CHAPTER 8: PRINT DRUM
9. Drum Flanges F (front) & R (rear)
REMOVAL
) Remove the Drum out from the machine and pull out the ink bottle.
2) Remove the Drum cover. (M3x8 screws; 4 pcs)
3) Remove following parts.
Clamp plate base unit (M4x8 screws; 4 pcs)
Drum screen (M4x8 screws; 4 pcs)
Drum body (M4x8 screws; 6 pcs)
4) Remove the Ink bottle switch cover. (M3x8 screws; 2 pcs)
5) Remove the upper and lower Ink bottle guides. (M3x8 screws; 3 pcs)
6) Unplug the Bottle set switch wire harness.
7) Unplug the RF-PCB wire harness.
8) Remove the Holder bracket. (M3x8 screws; 2 pcs)
9) Remove the Ink intake nozzle bracket. (M3x8 screws; 3 pcs)
10) Remove the Ink bottle base. (M3x8 screws; 4 pcs)
11) Remove the Grip handle. (M4x8 screws; 4 pcs)
2) Unplug the Inking motor wire harness connector and remove the mounting screws of the Inking
motor to detach the Inking motor. (M4x10 screws; 2 pcs)
13) Remove the Ink pump base. (M3x8 screws; 2 pcs)
4) Unplug the Ink sensor wire harness connector.
15) Remove the Ink sensor assembly. (M3x8 screws; 2 pcs)
16) Remove the wire harness band from the Ink sensor relay wire harness, and detach the Side
channel. (M4x8 screws; 4 pcs)
17) Unplug the Drum wire harness connector, and remove the Rear support plate. The order of the
screws to remove are: IB-lock screw 4x5, set screw, and then Cap screw. Only the top IB-lock
screw M4x5 needs to be removed.
18) Remove the Front support plate. The order of the screws to remove are: IB-lock screw 4x5, set
screw, and then Cap screw. Only the top IB-lock screw M4x5 needs to be removed.
9) Remove the Drum frange R.
20) Remove the Drum frange F.
Pump base
[ Refe
r to the photographs on the next page for the instructions given above.]
[ Also refer to the Precautions, which follow after the photographs.]
RISO Inc. Technical Services & Support
US.RISO.COM
