13 - 19
CZ180 / CV1860 Rev. 1.0
CHAPTER 13: PANEL MESSAGE
Error Type
D01 [Print drum not set]
Description
D01-xxx
Set Print Cylinder (Drum) in Place
To reset
display
Set the print drum in the machine.
Error Point
Error Conditions
526
Print drum is not set in the machine (drum connection signal, drum safety switch, and drum set
sensor are OFF.)
527
Print drum connection signal is OFF when the print drum was inserted in the machine.
528
Print drum safety switch is OFF when the print drum was inserted in the machine.
529
Print drum set sensor is OFF when the print drum was inserted in the machine (time-out: 5
seconds).
530
Print drum connection signal does not go OFF within 5 seconds after the print drum safety switch
went OFF when the print drum was pulled out.
Or, the print drum safety switch does not go ON within 5 seconds after the print drum connection
signal went ON when the print drum was inserted in the machine.
Error Type
D02 [Incorrect print drum]
Description
D02-xxx
Wrong-Type Print Cylinder Installed
Replace with Correct Type
To reset dis-
play
Set correct print drum in the machine.
Error Point
Error Conditions
532
Incorrect print drum is used.
Error Type
D03 [Ink cartridge not set]
Description
D03-xxx
Install Ink Cartridge
To reset
display
Install ink cartridge in the print drum.
Error Point
Error Conditions
533
Bottle set switch is OFF.
Error Type
D04 [Incorrect ink cartridge]
Description
D04-xxx
Wrong-type Ink Cartridge Installed or Cannot Read Ink Info
Replace Ink Cartridge or Contact dealer/Riso office
To reset
display
Replace with correct ink cartridge.
Error Point
Error Conditions
534
Incorrect ink cartridge is used.
560
Ink RF-Tag is not detected on ink bottle.
561
Ink RF-Tag communication error (communication with the ink cartridge was interfered by noise).
562
Wrong ink cartridge information on the Ink RF-Tag.
564
Detected a mismatch in the Ink RF-Tag serial number.
575
RF-Tag software error.
5) Set Check Errors (Dxx)
RISO Inc. Technical Services & Support
US.RISO.COM
