4 - 0
CZ80 / CV860 Rev. .0
CHAPTER 4: FIRST PAPER FEED
Upper limit sensor
Upper limit sensor position
Paper feed stay
Wire harness band
Upper limit sensor wire harness
The wire should not go under the red dotted line on the photograph.
6. Removal of Upper limit sensor
Removal
) Lower the Paper feed tray all the way down, turn OFF the machine power and remove the Master
removal lower cover. (3x8 screws; 2 pcs)
2) Remove the mounting screws from the sensor bracket and remove the sensor with the bracket.
(M3x6 screw; pc)
3) Detach the Upper limit sensor from the bracket and disconnect the wire harness connector.
Precaution in Assembly
) Match the positioning pins and positioning holes when attaching the Upper limit sensor bracket
back in position.
2) If the wire harness band was cut in above removal procedure, make sure to tie the sensor wire
harness back on the Paper feed stay using a new wire harness band.
3) In doing so, make sure that the wire harness does not sag under the dotted line shown on the
photograph.
4) This is to prevent the wire harness from being pinched by the Master removal lower cover.
Adjustment after installation
) Make adjustment on the Upper limit sensor position.
RISO Inc. Technical Services & Support
US.RISO.COM
