4 - 5
CZ80 / CV860 Rev. .0
CHAPTER 4: FIRST PAPER FEED
11. Removal of Guide plate
Removal
) Pull the Print drum out of the machine, turn OFF the machine power and remove the following
parts.
Front cover (M3x8 screws; 6 pcs)
Rear cover (M3x8 screws; 5 pcs)
Master removal lower cover (M3x8 screws; 4 pcs)
Paper feed tray unit
Paper feed clutch
Pickup roller shaft assembly
Elevator motor unit
Timing spring
2) Remove the front and rear Elevator spring brackets. (M3x6 screws; 2 pcs)
3) Remove the Pickup shaft support bracket. (M3x6 screw; pc)
4) Remove the Elevator rollers from the front and rear Elevator frame assemblies. (6mm dia.
E-rings; 4 pcs)
5) Remove Guide roller assembly (6mm dia. E-ring; 2 pcs).
6) Disconnect the wire harness connector of the Guide plate and remove the Guide plate. (M3x6
screws; 7 pcs)
Adjustment after the Assembly
) Hook the hook of the Guide plate on the metal bearing of the Timing roller.
2) Match the height of the gears on the front and rear Elevator frames.
[ Refer to the photographs on the next page.]
RISO Inc. Technical Services & Support
US.RISO.COM
