5 - 5
CZ80 / CV860 Rev. .0
CHAPTER 5: SECOND PAPER FEED
Mounting screw
3. Guide Roller Assembly
REMOVAL
) Pull out the Print drum, turn the machine power OFF and remove following part.
Rear cover. (M3x8 screws; 5 pcs)
2) Open the PCB bracket on the rear of the machine. (M3x8 screws; 4 pcs)
3) Remove the Guide roller spring.
4) Remove the mounting screws of the Timing lever assembly. (M4x8 screw; pc)
5) Remove E-ring and metal bushing, which can be seen after removing the Timing lever assembly,
from the Guide roller spindle shaft. (8mm dia. E-ring; pc)
6) Remove E-ring and metal bushing, from the Guide roller spindle shaft on the front of the machine.
(8mm dia. E-ring; pc)
7) Detach the Guide roller assembly from the machine by once sliding the Guide roller spindle shaft
to the rear of the machine to clear the front end out of the machine.
Guide roller assembly
RISO Inc. Technical Services & Support
US.RISO.COM
