5 - 7
CZ80 / CV860 Rev. .0
CHAPTER 5: SECOND PAPER FEED
Vertical print positioning pulse motor
5. Vertical Print Positioning Pulse Motor
REMOVAL
) Turn OFF the machine power and remove Rear cover. (M3x8 screws; 5 pcs)
2) Open the PCB bracket on the rear of the machine. (M3x8 screws; 4 pcs)
3) Remove the Sector gear spring.
4) Disconnect the wire harness connectors of the Vertical print positioning HP sensor and Vertical
print positioning pulse motor.
5) Remove E-ring from the Cam follower arm and remove the Cam follower arm from the Sector
gear. (6mm dia. E-ring; pc)
6) Remove Mounting screw of the Vertical print positioning base unit and remove the unit. (M4x6
screw; pc) (M3x6 screws; 3 pcs)
7) From the Vertical print positioning base unit, remove both the Vertical print positioning cam and
Intermediate gear. (6mm & 4mm dia. E-rings; pc each)
8) Remove Mounting screws of the Vertical print positioning pulse motor, and detach the motor.
(M3x6 screw; 2 pcs)
Precaution in Assembly
) Insert the pin on the Print positioning plate into the whirl groove of the Print positioning cam.
RISO Inc. Technical Services & Support
US.RISO.COM
