5 - 9
CZ80 / CV860 Rev. .0
CHAPTER 5: SECOND PAPER FEED
Timing roller
7. Timing Roller
REMOVAL
) Turn the machine power OFF, pull out the print drum and remove following parts.
Front cover (M3x8 screws; 6 pcs)
Rear cover (M3x8 screws; 5 pcs)
Guide plate
Load spring, Guide roller spring and Sector gear spring
Timing Cam (6mm dia. E-ring; pc)
Vertical print positioning base unit
Paper feed clutch
Sector gear
Guide roller assembly
2) Remove E-ring from spur gear, and detach spur gear from the shaft. (6mm E-ring; pc)
3) Remove E-ring from Timing roller on both ends, and detach Metal bushing from both ends. (8mm
E-ring; 2 pcs)
4) Slide the Timing roller to the rear once, and remove from the Timing roller out of the machine
through the opening above the paper feed tray.
Adjustment after Assembly
) Mounting position adjustment of Timing cam
Timing roller
RISO Inc. Technical Services & Support
US.RISO.COM
