Replacing and Disposing Consumables
Replacing the Master Roll
70
Tip:
• If you cannot insert the leading edge of the
master well, use the following procedure:
1) Raise the Master Guide Flap.
Turn the wheel beside the Master Guide Flap
inward to raise the Master Guide Flap.
2) Pull out the Master Roll up to the line
indicated by the arrows.
3) Lower the Master Guide Flap to the
original position.
10
Return the units to the original posi-
tions.
Close the Master Making Unit Cover, return the
Master Making Unit to the original position, and
then close the Front Cover.
Replacing and Disposing Consumables
Emptying the Master Disposal Box
71
Emptying the Master Disposal Box
1
Pull out the Master Disposal Box.
Grasp the handle of the Master Disposal Box and
pull out the box to the left.
2
Discard the ejected masters.
Note:
• If masters adhere to the inside of the Master
Disposal Box, press the lever located on the
handle.
3
Place the Master Disposal Box into
position.
Insert the Master Disposal Box until it stops.
Note:
• Dispose the ejected masters according to the
disposal rule of your local community.
)
p.72
Riso Kagaku Technical Training Center Version
