Safety Guide - Cleaning
76
Cleaning
Safety Guide - Cleaning
This section describes the precautions to be observed when cleaning the machine.
Read this section before cleaning the machine.
A
WARNING:
• Before cleaning any part of the machine, turn off the power.
• Do not remove any fixed covers.
• Contact your service representative immediately if you suspect any dangerous situations or have questions or
problems with the machine.
• Contact your service representative before moving the machine.
• Do not allow unauthorised persons to make adjustments or repairs.
B
Caution:
• The machine has precision moving parts inside. Do not handle the machine in any other way than described in this
guide.
• Be careful of the edge of metal parts, otherwise it may cause an injury.
• Do not make any modifications to the machine or remove any parts.
• Neither RISO nor its dealer is responsible for maintenance service performed by non-RISO-authorized personnel.
Replacing and Disposing Consumables
Removing and Installing the Print Cylinder (Drum)
73
Removing and Installing the Print
Cylinder (Drum)
When replacing with a color cylinder(drum) or dealing with paper jams, remove the Print Cylinder(Drum), take a nec-
essary procedure, and then install the cylinder(drum).
Important!:
• Make sure to place and keep the removed Print Cylinder(Drum) horizontal.
• Make sure to place the replaced Print Cylinder(Drum) in the cylinder(drum) case and keep it horizontal.
1
Open the Front Cover.
2
Check that the indicator of the Print
Cylinder(Drum) Release button is
on.
If the indicator is off, press the Print Cylin-
der(Drum) Release button to turn on its indicator.
:Print Cylinder(Drum) Release button
Note:
• With the Master Making Unit pulled out, you
cannot remove the Print Cylinder(Drum).
Place the Master Making Unit into position, and
then press the Print Cylinder(Drum) Release
button.
3
Pull out the Print Cylinder(Drum).
Grasp the Print Cylinder(Drum) Handle and pull
out the Print Cylinder(Drum) until it stops.
4
Remove the Print Cylinder(Drum).
Lift the Print Cylinder(Drum) with both hands to
remove it from the guide.
B
Caution:
• Do not touch the connector on the Print Cylinder(Drum).
Neglecting this may result in malfunction of the
Print Cylinder(Drum) because of static electric-
ity or other factors.
Riso Kagaku Technical Training Center Version
