Safety Guide - Installation
12
Before Starting to Use
Safety Guide - Installation
This section describes the precautions to be observed when installing the machine. Read this section before install-
ing the machine.
Note:
• Your dealer will help you to determine a proper location for the machine at the time of delivery.
Installation
A
WARNING:
• Place the machine on the dedicated stand for this model or on a flat and stable surface (maximum of
3
/
8
inches
(10 mm) differential allowed). Injury might occur if the machine falls.
• Install the machine in a well-ventilated area. Failure to do so may result in serious health problems.
B
Caution:
• Install the machine near the electrical outlet to avoid using an extension cord between the machine and the elec-
trical outlet. If an extension cord is absolutely required, do not use one longer than 15 feet (5 m).
• Allow at least 4 inches(10 cm) or more of clearance behind the machine so that you can unplug the machine in
case of technical difficulties.
• Keep the machine away from dusty environments. Failure to do so may result in fire.
Important!:
• Avoid installing the machine in the locations listed below. Failure to observe this precaution may lead to machine
failure.
– Locations with exposure to direct sunlight, such as locations close to windows (Curtain all windows that might
expose the machine to direct sunlight)
– Locations that are subject to sudden changes in temperature
– Extremely hot and humid locations or cold and dry locations
– Heated locations
– Locations exposed to direct cold air, direct hot air, or direct radiant heat
Getting Acquainted
Control Panels
9
16)
+ Key
Use when setting up for programmed printing or
when changing the initial settings.
17)
×
Key
Use when setting up for programmed printing.
18)
Start Key
Starts master-making or printing process or exe-
cutes specified operations.
The key is lighted only when the key is active.
19)
Proof Key
(
Use when you want to check print result after
adjusting the print position, for example.
This allows you to print sample copies without
affecting the value on the Print Quantity Display.
20)
Reset Key
Returns all settings to the initial settings.
21)
Stop key
Stops operation in progress.
Riso Kagaku Technical Training Center Version
