Before Starting to Use
Preparing to Print
20
Adding or Replacing Paper
When you add paper or replace with paper of a different size at the time of printing, press the Feed Tray Descent But-
ton to lower the Paper Feed Tray.
Pressing the button gently causes the tray to be lowered to the bottom. If you press and hold the button, the tray is
lowered until you release the button.
When the tray runs out of paper or you remove all paper, the tray is automatically lowered to the bottom.
Important!:
• Do not mix paper of different sizes.
• After replacing with paper of a different size, reposition the Receiving Tray Paper Guides and Paper Stopper
according to the size of the replacement paper.
Before Starting to Use
Originals
17
Originals
Size and Weight Restrictions
Usable originals are as follows.
• Originals are scanned according to the size of paper placed on the Paper Feed Tray when masters are made; for
the same width, the positions of the Feed Tray Paper Guides.
When the placed paper is smaller than an original, not the entire original will be scanned.
When the placed paper is larger than an original, dirt on the glass or shade of the original, for example, may result
in unexpected dirt in the area beyond the size of the original.
• Bound originals can also be used on the Stage Glass.
• You can feed automatically up to 50 original sheets when using the optional ADF (Automatic Document Feeder)
unit.
Note:
• Use the Stage Glass when printing the following originals:
– Patched or worn originals
– Wrinkled, curled, folded, or torn originals
– Transparent originals (such as tracing paper or OHP transparencies)
– Chemically treated originals (such as thermal or carbon paper)
– Originals with correction fluid or glue
– Extremely thin originals (less than 15-lb bond(50 g/m
2
))
– Extremely thick originals (greater than 28-lb bond(110 g/m
2
))
– Heavy drawing paper
– Originals with staples or clips
• If an original is wrinkled, curled, or creased flatten it thoroughly so that the originals can be pressed directly onto
the Stage Glass during processing.
• If correction fluid or glue is used on an original, thoroughly dry it before placement.
• For an original patched with thick paper, the shade of the patched paper may also be printed.
Model
Using the Stage Glass
Using the Optional ADF unit
Size
Weight
Size
Weight
RZ390/
RZ370/
RZ310
1
15
/
16
"
×
3
9
/
16
"(50 mm
×
90 mm) to
11
11
/
16
"
×
17"(297 mm
×
432 mm)
Max.22lb
(10kg)
3
9
/
16
"
×
5
1
/
2
"(90 mm
×
140 mm) to
11
11
/
16
"
×
17"(297 mm
×
432 mm)
15-lb bond
(50g/m
2
) to
28-lb bond
(110g/m
2
)
RZ230/
RZ220/
RZ200
1
15
/
16
"
×
3
9
/
16
"(50 mm
×
90 mm) to
10
1
/
8
"
×
14
5
/
16
"(257 mm
×
364 mm)
3
9
/
16
"
×
5
1
/
2
"(90 mm
×
140 mm) to
10
1
/
8
"
×
14
5
/
16
"(257 mm
×
364 mm)
Riso Kagaku Technical Training Center Version
